AWG 64 MB MEMORY CARD FOR WII Specifiche Pagina 20
- Pagina / 62
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
TEAM Climate Monitoring Protocol 3.0
20
2. Take pictures: This information is crucial to get accurate information about the site
where the station is located. Repeat this process every year to document changes in the
physical characteristics of the site.
• Mount a camera with a wide angle lens on a tripod, 1.5 m above the ground in the
exact location where the station will be located. Level the camera so it is completely
horizontal and not angled.
• Take a picture facing north.
• Rotate the camera 30 degrees to the East and take another picture.
• Keep rotating the camera 30 degrees and taking pictures each time, until back facing
north.
• Upload these photos to the TEAM portal as part of the climate metadata. See Section
6.1.4 on where to upload the photos and the Site Metadata Form.
3. Characterize heights and distances to objects: These data can be used to construct a
height and distance profile of the site where the climate station is located. These
measurements should be repeated every year to track changes in the physical
characteristics of the site.
• Position yourself in the exact location where the station will be (is) placed and facing
north.
• Measure the distance to the nearest object (e.g. tree, house using the laser range finder
and record this value the Site Metadata Form.
• Measure the angle in degrees to the top of the object using the clinometer. Record the
value in the Site Metadata Form.
• Rotate 5 degrees to the East and repeat the above three steps.
• Keep rotating 5 degrees to the East until you are back facing north
• See Section 6.1.4 on where to upload the Site Metadata Form.
5 ASSEMBLY OF THE CLIMATE STATION
This section describes the whole process of setting up the climate station from the moment the
equipment is received to a full test run of the climate station with all its sensors. The process is
outlined in general with the main steps; for details refer to the instruction manuals accompanying
the base tower, data logger and sensors.
- Table of Contents 3
- 1 INTRODUCTION AND SCOPE 4
- 2 GOALS AND IMPLEMENTATION 6
- 3.1 Base -UT10 tower 7
- 3.2 Data logger -CR1000 7
- 3.3 Sensors 7
- 3.4 Power supply 8
- 4.2 Level 1 Siting 11
- 4.3 Level 2 Siting 13
- 4.4 Level 3 Siting 18
- 4.5 Level 4 Siting 18
- 4.6 Ordering the Equipment 18
- 5.5 Installing the sensors 28
- Campbell 2008) 31
- 5.7 Test run the station 33
- 5.6 Finishing steps 33
- 6.1 Data Retrieval 34
- 6.3 Regular Maintenance 36
- 6.4 Sensor Calibration 39
- 7 REFERENCES CITED 43
- 8 GLOSSARY 44
- (Continues into next page) 48
- Sensor Calibration Metadata 59
Prodotti e manuali riguardandi Misurazione, test & controllo AWG 64 MB MEMORY CARD FOR WII
(285 pagine)LockState LS-20ED manuali
Manuali dei proprietari e guide per l'utente per Per casa LockState LS-20ED.
We fornisce 1 manuali pdf LockState LS-20ED per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Commenti su questo manuale